Key-in-ignition "warning chime"
#1
Key-in-ignition "warning chime"
2001 Expedition XLT
When I turn it off, take the key out of the ignition and open the driver door, I get the "warning chime" as if the key was still left in the ignition. If I wiggle the ignition a bit, I can get it to stop. But it does this almost every time the truck is turned off. Any ideas?
When I turn it off, take the key out of the ignition and open the driver door, I get the "warning chime" as if the key was still left in the ignition. If I wiggle the ignition a bit, I can get it to stop. But it does this almost every time the truck is turned off. Any ideas?
#2
2001 Expedition XLT
When I turn it off, take the key out of the ignition and open the driver door, I get the "warning chime" as if the key was still left in the ignition. If I wiggle the ignition a bit, I can get it to stop. But it does this almost every time the truck is turned off. Any ideas?
When I turn it off, take the key out of the ignition and open the driver door, I get the "warning chime" as if the key was still left in the ignition. If I wiggle the ignition a bit, I can get it to stop. But it does this almost every time the truck is turned off. Any ideas?
#3
#4
Did not have to get a new ignition....I was installing a car alarm and had to install a bypass module ring on the ignition. You will see it just push on the sensor with the key out and the door open the chime should stop.
Thread
Thread Starter
Forum
Replies
Last Post