Sandblasting shops?
#1
Sandblasting shops?
Anyone know of any shops around aurora that does sandblasting for truck bodies? I am thinking about having my cab sandblasted, but when I called around a few places, they only did sandblasting for large projects like the city. And if so what it might run me? Thanks!
Mike
Rompin 78'
78' Ford F-150 4x4
Mike
Rompin 78'
78' Ford F-150 4x4
#2
Sandblasting shops?
Mike:
There is a place in Golden, the name excapes me at the moment but they seem reasonable. I had called on getting the bed from by 65 done and they quoted "around $200". They were very friendly and din't mind when I went down the list of hood, fenders, frame, engine parts... Seemed like the going rate was $50 per item. They also dip parts and/or they use other media that is less destructive than sand. Give me a day to get you the name if you wish.
--Mike G
There is a place in Golden, the name excapes me at the moment but they seem reasonable. I had called on getting the bed from by 65 done and they quoted "around $200". They were very friendly and din't mind when I went down the list of hood, fenders, frame, engine parts... Seemed like the going rate was $50 per item. They also dip parts and/or they use other media that is less destructive than sand. Give me a day to get you the name if you wish.
--Mike G
#4
Sandblasting shops?
You got it!
A-1 Auto & Metal Stripping. They are petty much off of I-70 and 44th, then West almost to McIntyre. Some prices were fenders/hood/doors $50 each, bed/gate $200, frame $190, headers $30. Same for blasting or dipping. You can talk to Richard or Jim at 303-279-1930
At those prices, I may just drive the beater up there right into the tank!
--Mike G
A-1 Auto & Metal Stripping. They are petty much off of I-70 and 44th, then West almost to McIntyre. Some prices were fenders/hood/doors $50 each, bed/gate $200, frame $190, headers $30. Same for blasting or dipping. You can talk to Richard or Jim at 303-279-1930
At those prices, I may just drive the beater up there right into the tank!
--Mike G
Thread
Thread Starter
Forum
Replies
Last Post