Need help with 2006 Expedition front brakes
#1
Need help with 2006 Expedition front brakes
So I went to replace the front pads yesterday and ran into a sticking point. It appears I don't have the correctly sized hex to get off the caliper sliding pins on the back side of the caliper.
Does anyone know the size of these? I tried 8mm, 5/16 which were too small and 10mm and 3/8 seemed to be too large. Also, is it good practice to replace these as well? Slightly frustrated at this point. Thanks for any help on this.
Does anyone know the size of these? I tried 8mm, 5/16 which were too small and 10mm and 3/8 seemed to be too large. Also, is it good practice to replace these as well? Slightly frustrated at this point. Thanks for any help on this.
#4
#6
Sorry, I can't help it, it's a curse.
Kragen auto parts stores also carry it if you have one near you.
http://www.sears.com/shc/s/p_10153_1...00010000100600
Kragen auto parts stores also carry it if you have one near you.
http://www.sears.com/shc/s/p_10153_1...00010000100600
#7
Trending Topics
#8
#9
If you don't want to wait...go to a hardware store, get 2 bolts with 9mm heads and 4 nuts to fit the bolts. Screw two nuts on to the ends of each bolt, then tighten them together real tight. Now you can stick the head of the bolt into the caliper bolt and use a socket or wrench on the nuts to spin it out.
Thread
Thread Starter
Forum
Replies
Last Post
JJMac22
1987 - 1996 F150 & Larger F-Series Trucks
6
10-05-2021 04:12 PM
housetruck
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
10
10-04-2016 12:54 PM
bnovak
1997-2006 Expedition & Navigator
22
09-25-2016 10:40 AM
powerstroker100
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
2
09-12-2010 02:48 PM