We should start a "Junk Yard Watch".
#1
#2
#3
#6
We should start a "Junk Yard Watch".
[updated:LAST EDITED ON 06-Jun-02 AT 02:02 AM (EST)]I will HAVE to check out Pull and Save! I am currently swapping out a 85 Bronco 300 I 6, going to a 85 Bronco 302 EFI. Changing over to a Holley 600 w/ Weiand intake, as I don't want to go to the trouble to change the wiring harness. I will need to pick up a flywheel and another older distributor. Need to change out the clutch, but will go witha new unit here.
I hate to say it, but I just sent a the donor 85 Bronco to La La Land.... one of those places that haul shells away for free. No good sheet metal, but it did have all the glass except a cracked windshield. No engine, tranny, or transfer case. I pulled the no rust tailgate off for mine though.
I live up in the NW side of town, no yards. I have used the yards on Federal, up north on I-25, and Sviegels down on Sante Fe. Too bad we lost Bill and Al's.........
Also think it is a great idea to post what we are looking for and having anyone going out to check on the parts! I'll bookmark this message base and check it often!
I hate to say it, but I just sent a the donor 85 Bronco to La La Land.... one of those places that haul shells away for free. No good sheet metal, but it did have all the glass except a cracked windshield. No engine, tranny, or transfer case. I pulled the no rust tailgate off for mine though.
I live up in the NW side of town, no yards. I have used the yards on Federal, up north on I-25, and Sviegels down on Sante Fe. Too bad we lost Bill and Al's.........
Also think it is a great idea to post what we are looking for and having anyone going out to check on the parts! I'll bookmark this message base and check it often!
Thread
Thread Starter
Forum
Replies
Last Post
BTFordGuy302
1987 - 1996 F150 & Larger F-Series Trucks
9
08-30-2016 09:46 AM
ctubutis
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
6
05-06-2014 08:07 PM