Looking for some parts
#1
#2
C1TF11661B .. HeadLamp Switch **** & Shaft Assy / Obsolete
Fits: 1961/67 Econoline / 1961/66 F100/600.
MATLOCK FORD-MERCURY in Franklin IN has TWO = 800-987-3673.
FRED GRANDE FORD in Richmond MI has TWO = 586-727-3415.
GREEN SALES CO. in Cincinnati OH has TWO = 800-543-4959.
JST AUTOMOTIVE in Lebanon TN has FOUR = 615-443-3086.
-----------------------------------------------------------
C1TF10852C .. Instrument Cluster Bezel "Lights" / Obsolete
Fits: 1961/67 Econoline
PHILIP MOTOR CO. in Philip SD has ONE = 800-859-5557.
GRIESEL MOTOR CO. in Okarche OK has ONE = 405-263-7242.
No other Ford Dealer, no obsolete parts vendor has any.
------------------------------------------------------
C1UZ8922800C .. Right Upper Door Hinge / Obsolete
Fits: 1961/67 Econoline
WILLEY, INC. in Ames IA has ONE = 515-233-1913.
WESLEY OBSOLETE PARTS in Liberty KY has FOUR = 606-787-5293.
GREEN SALES CO. has FIVE.
Note: To use this hinge on the left side, reverse the hinge pin.
This procedure may seem odd, but it's as original.
--------------------------------------------------------
Next time you ask questions, please type the year.
Searching thru one parts catalog (1957/63) is easier than searching thru two ('64/72).
#3
#4
I have seen an early model Econoline (1961 - 1964) instrument panel that appears to have been an option, that has gauges instead of the warning lights for the generator and oil pressure. Any chance that one might be kicking around anywhere. Is there maybe a suitable update available??
Thanks again for the help.
Joe - Southern California
Thanks again for the help.
Joe - Southern California
#5
Since you didn't mention the year, I had to look in both to see if the part numbers were the same 1961/63 & 1964/67 for the bezel, the **** and shaft.
I knew from the get-go that the hinges were all the same.
---------------------------------------------------------
The headlamp switch (C2DZ11654A) is the same: 1961/64 E100, 1960/63 Falcon/Comet.
But the E100 headlamp **** and shaft (C1TF11661B) is not the same as Falcon/Comet (C1DZ11661A) **** and shaft.
The dash configuration is different, the Falcon/Comet **** does not look the same as the E100 ****.
The E100 "Lights" bezel is not the same as Falcon/Comet.
--------------------------------------------------------
The two idiot light lenses for the OIL & GEN fit into bezels that are removeable.
The optional Oil (C1TF9273A) and Gen (C1TZ10850A) Gauges fit into these same two locations in the instrument cluster.
From the parts catalog pic, everything else is the same.
But...you will also need the specific dash wiring harness used when these two gauges are present, the oil pressure sending switch instead of the one used with an idiot light.
I found 36 NOS oil gauges, 41 NOS Gen gauges, the oil pressure sending switch is EZ to find at autoparts stores, but where will you find the wiring harness?
No one had any.
#7
Trending Topics
#8
Parts catalog pic shows the gauges fitting into the same spots as the idiot light bezels without any additional parts required.
The instrument cluster face has four holes in it, the cluster back that the gauges fit into is the same for idiot light bezels.
So...all you need are the gauges, the oil pressure sending switch (the one for the light is different)...and the wiring harness.
#9
#11
The switch is the same as early Falcon. These are reproduced and available from Macs, Dearborn Classics, Autokrafters and Dennis Carpenter.
#12
C2DZ11654A .. Headlamp Switch (Motorcraft SW303) / Obsolete
Fits: 1961/67 E100 / 1960/63 Falcon/Comet.
For those that want an original Genuine Ford switch, instead of a reproduction switch made in China...
B & L FORD in Ashland PA has ONE = 570-875-4417.
KOVATCH FORD in Nesquehoning PA has ONE = 570-669-5118.
HAVEN FORD SALES in Haven KS has ONE = 800-748-7803.
Fits: 1961/67 E100 / 1960/63 Falcon/Comet.
For those that want an original Genuine Ford switch, instead of a reproduction switch made in China...
B & L FORD in Ashland PA has ONE = 570-875-4417.
KOVATCH FORD in Nesquehoning PA has ONE = 570-669-5118.
HAVEN FORD SALES in Haven KS has ONE = 800-748-7803.
#13
mr number dummy,
hi, sir i own two of the origional bull fenders emblems that came factory stock on a 70 ranchero that i owned and drove for years, i loved that truck and i would still have save the fact a very good friend of mine totataled it. my point i have no facts, but i suspect they are rare. do i have something special, or are they reproduced. so you will know, i decided to move on and divest them, i would like some one who is restoring to have them, any thoughts sir. paul md.
#14
emblems
i found out my bull emplems are reproduced, and very cheap at that. even though mine are for real 70 vintage, you cannot tell the diff from thr repops. i wanted to helpsomeone restoring but i dont have anything special at all as it turns out. later fellas. my vote is for 1970, best ford i ever owned. paul md
Thread
Thread Starter
Forum
Replies
Last Post
Jmiller68
1967 - 1972 F-100 & Larger F-Series Trucks
4
01-02-2017 03:10 PM
BURNSTOUGHFORD
1987 - 1996 F150 & Larger F-Series Trucks
40
03-27-2013 05:22 PM
Rovah
Electrical Systems/Wiring
3
10-14-2004 08:16 PM