Glow plug relay wiring diagram
#1
#2
I'll post this link to help but I'm not sure if the early '99's are the same as the rest.
Welcome to guzzle's Stancor GPR replacement Mod Web Page
Look at the picture caption "Remove the Old GPR"
Welcome to guzzle's Stancor GPR replacement Mod Web Page
Look at the picture caption "Remove the Old GPR"
#4
I'll post this link to help but I'm not sure if the early '99's are the same as the rest.
Welcome to guzzle's Stancor GPR replacement Mod Web Page
Look at the picture caption "Remove the Old GPR"
Welcome to guzzle's Stancor GPR replacement Mod Web Page
Look at the picture caption "Remove the Old GPR"
#6
#7
Trending Topics
#8
3 & 5 could be reversed and the relay will still operate. With key on you will see battery on both with one lead to ground. You will be reading the voltage through the winding. You need to lift the wires off the posts to isolate them and then read their potential with key on.
Edit: Nice diagram Jim. Does what I said make since?
#9
3 & 5 could be reversed and the relay will still operate. With key on you will see battery on both with one lead to ground. You will be reading the voltage through the winding. You need to lift the wires off the posts to isolate them and then read their potential with key on.
Edit: Nice diagram Jim. Does what I said make since?
Edit: Nice diagram Jim. Does what I said make since?
Thanks!
#11
Sorry in advance for the necropost, but on this page, http://api.viglink.com/api/click?for...d%20Web%20Page , On the diagram "Remove the Old GPR", what is the purple wire on the output terminal?
#12
That wire goes to pin 8 of the PCM (Glow Plug Monitor). Somewhere along the way there is a fusible link and wire changes color to White/Lt Grn.
Thread
Thread Starter
Forum
Replies
Last Post