Husky Liners Molded MudGuards Install
#1
Husky Liners Molded MudGuards Install
For those of you who are interested I have decided to post some pics of my install for the Husky Liner Custom Molded MudGuards for the 07 and up Expeditions.
When I had my 02 Explorer I liked the look of the OEM molded mudflaps and was hoping once I got the Expedition I would be able to add them as well.
No luck.. they only sell the flat mudflaps so I decided to try out the Husky Liner version.
Front
#56631
Close-up
Rear
#57631
Close-up
Each set comes with a strip of 3M paint protection film to apply to installation area.
You must mark the drill locations to fit the u-clips. You also use the existing screws for the install.
Post install pics
Front Drivers side
http://i309.photobucket.com/albums/k...all_07Ex-8.jpg
Close up of the molded mudguard to the OEM side steps.
Rear passenger side
Spacing between the mudguard and tail pipe.
Prior - Rear
Post - Rear
The installation was fairly simple.
I was lazy and chose not to remove the tires for the install.
The instructions say it may be necessary to removed the wheels.
Drilling the innner most hole was the difficult part but not impossible.
For the front set I turned the wheel to give me more room for installation.
I also decided to forego the 3M protection film for the front set, only because I'm pretty sure I will not be removing them.
Total installation time was about an hour(30mins per set).
I am very happy with how well exact the mold was to the fender wall and the OEM side steps.
I highly recommend them and I hope you enjoyed the pictures.
When I had my 02 Explorer I liked the look of the OEM molded mudflaps and was hoping once I got the Expedition I would be able to add them as well.
No luck.. they only sell the flat mudflaps so I decided to try out the Husky Liner version.
Front
#56631
Close-up
Rear
#57631
Close-up
Each set comes with a strip of 3M paint protection film to apply to installation area.
You must mark the drill locations to fit the u-clips. You also use the existing screws for the install.
Post install pics
Front Drivers side
http://i309.photobucket.com/albums/k...all_07Ex-8.jpg
Close up of the molded mudguard to the OEM side steps.
Rear passenger side
Spacing between the mudguard and tail pipe.
Prior - Rear
Post - Rear
The installation was fairly simple.
I was lazy and chose not to remove the tires for the install.
The instructions say it may be necessary to removed the wheels.
Drilling the innner most hole was the difficult part but not impossible.
For the front set I turned the wheel to give me more room for installation.
I also decided to forego the 3M protection film for the front set, only because I'm pretty sure I will not be removing them.
Total installation time was about an hour(30mins per set).
I am very happy with how well exact the mold was to the fender wall and the OEM side steps.
I highly recommend them and I hope you enjoyed the pictures.
#2
#7
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
KrenzyRyan
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
36
09-21-2013 05:47 PM