dyno video Flathead @ 335hp
#1
dyno video Flathead @ 335hp
http://youtube.com/watch?v=U8x47lRNslc
or here it is in action in the orange car
http://youtube.com/watch?v=AhLcHV3iVNU
Guess it ran a 10.994 1/4 mile not bad for 239 cubic inches.
or here it is in action in the orange car
http://youtube.com/watch?v=AhLcHV3iVNU
Guess it ran a 10.994 1/4 mile not bad for 239 cubic inches.
#2
Join Date: Dec 2003
Location: Saskatoon, Saskatchewan
Posts: 89,686
Received 1,353 Likes
on
1,112 Posts
#4
i can tell you the blower itself is around 8k plus another 1k for the aluminum pulleys and belts, around 750 for the aluminum mallory dist, about 700 for the offy heads, 400 for the likely 4"crank and the same for the intake and 500 for the cam, prolly bored out so give or take a bit.... 3.5-5k for machining and pistons and rods etc. It prolly has dual 4 barrels so lets say 350 each new. Grand total is prolly $16k-18.5K (guestimate)
Last edited by effie_man; 12-23-2007 at 12:32 AM.
#7
Join Date: Dec 2003
Location: Saskatoon, Saskatchewan
Posts: 89,686
Received 1,353 Likes
on
1,112 Posts
Trending Topics
#9
Join Date: Dec 2003
Location: Saskatoon, Saskatchewan
Posts: 89,686
Received 1,353 Likes
on
1,112 Posts
#12
Join Date: Dec 2003
Location: Saskatoon, Saskatchewan
Posts: 89,686
Received 1,353 Likes
on
1,112 Posts
#14
Thread
Thread Starter
Forum
Replies
Last Post
asemastermech
General NON-Automotive Conversation
18
09-29-2011 04:53 PM
BlueOvalBud
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
22
01-24-2011 04:38 PM