Temp sending unit location
#1
#4
Temp sending unit location
The sender for the guage is on the passenger side of the head towards the rear, kind of a tricky place to get to. You may have another temperature sender near the thermostat housing if your truck has a computer; it doesn't affect the guage though.
--------------
[font color="green"]1995 F-150 Supercab XLT longbed 4x4 302 M5OD [/font]31x10.50's
[font color="green"]1986 F-150 4x4 300 I6 NP435 [/font]Warn hubs, DeeZee bed caps, '96 XLT bench seat, new paint job
--------------
[font color="green"]1995 F-150 Supercab XLT longbed 4x4 302 M5OD [/font]31x10.50's
[font color="green"]1986 F-150 4x4 300 I6 NP435 [/font]Warn hubs, DeeZee bed caps, '96 XLT bench seat, new paint job
#5
#6
Temp sending unit location
I found it. Thanks, Can someone verify the correct wire for me. There is a wire in a plastic loom that is hooked into a bracket right behind the head. Is this the correct wire? I couldn't tell what color it was other than it was darak, it is cut off too so it has no end on it.
#7
Temp sending unit location
That sounds like it, I seem to remember mine as a dark color. Haynes manual says it's red-white stripe.
--------------
[font color="green"]1995 F-150 Supercab XLT longbed 4x4 302 M5OD [/font]31x10.50's
[font color="green"]1986 F-150 4x4 300 I6 NP435 [/font]Warn hubs, DeeZee bed caps, '96 XLT bench seat, new paint job
--------------
[font color="green"]1995 F-150 Supercab XLT longbed 4x4 302 M5OD [/font]31x10.50's
[font color="green"]1986 F-150 4x4 300 I6 NP435 [/font]Warn hubs, DeeZee bed caps, '96 XLT bench seat, new paint job
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
kabcpapc
Modular V8 (4.6L, 5.4L)
1
09-06-2014 05:35 PM
SVTDriver97
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
8
06-10-2014 06:21 PM
PRIMERED79 SHORT BED
1973 - 1979 F-100 & Larger F-Series Trucks
14
09-05-2013 09:52 PM
lm987
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
2
06-12-2013 10:32 AM