slades park
#3
#5
Well. . .
To get it back up and running, it needs a motor
I need to finish the front axle trusse/frame and mount the axle.
I need to finish the cab mounts and treat the bottom and it can go back on the frame.
I have to swap rears.
The fuel system needs to be installed.
Brakes. . .
Electrical. . .
. . .A lot of work. Ok, a lot of small steps but I just haven't had it as a top priority. Hell, I even though about selling it till I get my own place (only briefly lol).
Right now, I'm R n' R'ing the motor and tranny in my red truck. Getting ready to drop the tranny in a few minutes actually,t hen pull the motor out the front
Wish me luck, cuzz there's gonna be alotta cussin'
To get it back up and running, it needs a motor
I need to finish the front axle trusse/frame and mount the axle.
I need to finish the cab mounts and treat the bottom and it can go back on the frame.
I have to swap rears.
The fuel system needs to be installed.
Brakes. . .
Electrical. . .
. . .A lot of work. Ok, a lot of small steps but I just haven't had it as a top priority. Hell, I even though about selling it till I get my own place (only briefly lol).
Right now, I'm R n' R'ing the motor and tranny in my red truck. Getting ready to drop the tranny in a few minutes actually,t hen pull the motor out the front
Wish me luck, cuzz there's gonna be alotta cussin'
Thread
Thread Starter
Forum
Replies
Last Post
FORDF250HDXLT
General NON-Automotive Conversation
66
07-01-2020 11:29 AM
chad77
1948 - 1956 F1, F100 & Larger F-Series Trucks
10
10-03-2016 01:11 PM
Slade901
1968-Present E-Series Van/Cutaway/Chassis
33
03-11-2004 11:02 PM