cold start problem
#1
cold start problem
Hey guys, It's been a while since my last post. I had a rod go bad on my '99
250SD, had a dealer put in a reman about 3000 miles ago. Now it stumbles real
bad at a cold start, then smoothes out and runs fine. I searched the site and
found possible IAC problem. Changed that this morning, didn't fix it. I'm thinking
fuel filter next? Also, I noticed last night that when I turn my lights on, my dash
and radio lights fade in and out. I searched the site for that too, maybe headlight switch? Any help is greatly appreciated, thanks in advance.
250SD, had a dealer put in a reman about 3000 miles ago. Now it stumbles real
bad at a cold start, then smoothes out and runs fine. I searched the site and
found possible IAC problem. Changed that this morning, didn't fix it. I'm thinking
fuel filter next? Also, I noticed last night that when I turn my lights on, my dash
and radio lights fade in and out. I searched the site for that too, maybe headlight switch? Any help is greatly appreciated, thanks in advance.
Thread
Thread Starter
Forum
Replies
Last Post
ssyputa
Clutch, Transmission, Differential, Axle & Transfer Case
7
05-06-2014 06:12 PM
tsedgar
Explorer, Sport Trac, Mountaineer & Aviator
0
10-18-2010 11:14 AM
chewyjackson
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
5
03-18-2008 09:23 PM