302 Back From Machining
#1
302 Back From Machining
This afternoon I got a call saying I could come pick up my block which I had boiled, along with new cam bearings and soft plugs installed. Also had the rod and rod caps turned to keep em round as well as had the crank turned .30 mains .20 rods. Tonight I got it back on the engine stand and all masked off for paint. Since the machine shop took all the money I had. I did not have money to go out and buy any engine paint and after searching the garage I found some Chevy orange engine paint. (i Know Gasp) Well the ford motor block dont look to bad Bowtie orange and when you on a budget like me paint is better then no paint ya know? Tommorow I will start putting it all back together. I still have not pulled the straight 6 outta the truck and yesterday we got about an inch of snow so I better get a move on. Any find yourselfs out by my place (cedar falls iowa) and want to drop in and shoot the sheeet your more then welcome too. Might even be able to use a hand or two never know.
Respects
Pan aka ford by four
Respects
Pan aka ford by four
#2
#3
#5
#6
#7
Guess I cant Private Message you and since I dont have my 15 days in I cant email you on here so drop me a private message or contact me at panheadjosh@webtv.net
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
1972fordhighboy
1967 - 1972 F-100 & Larger F-Series Trucks
4
01-13-2015 12:57 PM
Finger__Rachet
Performance & General Engine Building
9
01-01-2013 07:08 PM