I am looking for some one to help me out with welding on a patch panel on the bed of my truck.

I thought that I could handle it my self but I am in over my head now which sucks a lot.


pm, email, or leave one here if you think you could help me out.

 

Where are you located?

 

Ottawa

would drive to you though depending on where you are

edit: I looked on you profile and if Itasca is were you live then it is not to far from me about a hour and a 1/2 so that is not bad.

 

Did someone help you out? I'm in Palos Heights and could weld it for you.

 

no I did not get eny help. so I tried to do the best job that I could on the one side and it looks even wors then befor.

right now I am very short on $$ so I can not real do eny thing about it.
but I thenk that my best bet is to just get a new bed for the truck.

thank you for the offer though.

 

What spot of the bed are you welding? I'd drive out there and spend some time at Starved Rock and then help you out. I'm not looking for anything, just help a guy out is all.

 

on both sides over the wheel. I got a set of sheet metal panels
and tried to put the one on but I just Fed it all up so I most likely would have to get a new one or cut that one off and make it smaller and use a lot of body filer.

wish I could get pics of it becouse I realy can not explane it that good.

 

Did you resolve the problem? Are you able to drive it?