Sealing carburetor base gasket?
#1
Sealing carburetor base gasket?
My Motorcraft 2150 2bbl has a little nick in it's base plate. It can't be sanded without ruining the seal to the base plate gasket further. The carb is excellent otherwise, but sucks air loudly at the area where the nick is when running. Normally I would never seal a base plate gasket as most sealers, particularly silicon, will melt away in the presence of gasoline. But in this case, I'm wondering if there is some kind of sealer out there that will help with this? Any ideas? Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
kegger66
1973 - 1979 F-100 & Larger F-Series Trucks
22
06-30-2016 11:16 PM
Redbeard55
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
4
07-27-2011 06:35 PM
dani9678
Ford Inline Six, 200, 250, 4.9L / 300
6
03-11-2009 09:49 AM
murdocksvillian
335 Series- 5.8/351M, 6.6/400, 351 Cleveland
10
05-24-2006 08:36 PM