Cylinder head work- who and where?
#1
Cylinder head work- who and where?
Hello y'all.
I'm back. Took me long enuf.
Getting ready to have the heads done on my 460.
Any recommendations for a good shop- or at least
those ones to avoid?!? These are '73 heads. Pre-
unleaded era for sure.
So this is the best of "WWYD"- what would y'all do?
Besides use them for boat anchors . I've got
both sides of the debate on hardened valve seats.
And I don't know which. I do know that I'd like to
do them right the first time. After all, I'm gonna be
driving it for a long time...
Thanks in advance for any and all help!
white_knight
I'm back. Took me long enuf.
Getting ready to have the heads done on my 460.
Any recommendations for a good shop- or at least
those ones to avoid?!? These are '73 heads. Pre-
unleaded era for sure.
So this is the best of "WWYD"- what would y'all do?
Besides use them for boat anchors . I've got
both sides of the debate on hardened valve seats.
And I don't know which. I do know that I'd like to
do them right the first time. After all, I'm gonna be
driving it for a long time...
Thanks in advance for any and all help!
white_knight
#2
Cylinder head work- who and where?
I have my Aluminum heads done at Moritz over on Admiral & Yale. The shop guys are helpful & I've known 3 of them over 20 years. You have to tell Shirly EXACTLY how you want things done to get it the way you want. I'll assume they're either D3VE or D3TE heads & will most likely already have the exhaust seats in them. I have a set on mommas' '65 that I don't like so they'll get the D0VE's I have in the floor(I got 4 sets). I don't like them because they're prone to cracking.
#3
Cylinder head work- who and where?
Hey Qtrmiler
You are right- my heads are D3VE, block is D1VE.
Would you be interested in parting with a pair of
the D0VE's or know where I could locate a pair?
Email me in either case. And thanks for the ref.
I really didn't know where to begin.
Thanks again
Mark aka white_knight
You are right- my heads are D3VE, block is D1VE.
Would you be interested in parting with a pair of
the D0VE's or know where I could locate a pair?
Email me in either case. And thanks for the ref.
I really didn't know where to begin.
Thanks again
Mark aka white_knight
Last edited by White_Knight; 08-28-2003 at 02:49 AM.
#4
Cylinder head work- who and where?
What's your e-mail? Mines rick@tulsahotrods.com I have a few sets
Thread
Thread Starter
Forum
Replies
Last Post
White_Knight
Brakes, Steering, Suspension, Tires, & Wheels
14
11-23-2003 03:17 PM