Category: Exterior - Body Parts
Price: $0
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): Prelude
Item Condition: MA
Engine: Part suitable for gas truck

Newest addition:
1977 F150 Exlporer

1973 ford F100 short box. bed is not available.
1976 highboy 4 x 4 ranger xlt
1976 4 x 4

1977 3 speed manual transmission
1977 c4
1976,1977 c6
1973 c4 (needs to be rebuilt)
1976 divorced transfer case
8' Beds (2) both need some work
8' Ford Bedliner
1973 ford 302. Running 40,000 mile since rebuild
1976 351 M engine with Mickey Thompson Valve Covers
1977 351 Cleveland engine
Cabs (Total of three) 1973,1976,1977. all need work.
doors and door parts, fenders
Radiators and supports
Tailgate 73, tailgate parts
Exterior trim, grills, and grill inserts, bumpers
Brand new fuel tank used tanks, behind seat tank
3 sets of 4 hubcaps for 1973 and 1975,
Dana 60 rear end,
Dash pad decent, dash, dash pad cover
wire harnesses from four trucks,
Two brand new condition exhaust systems,
Steering columns and wheels, Seats
1977 f150 8' frame
1976 4 wheel drive frame
1973 f100 short bed frame
body replacement panels for fender and cab
(4) 33/12.5/16.5 Centennial Canyon Climber mudder tires

 

You have any 460 compatible stuff? I need a radiator and shroud, as well as brackets for power steering and alternator. Maybe a few other smalls. Thanks

 

Is the 76 4x4 a 150? Is it automatic with power steering?

 

The 4 x 4 is a 250. The Custom is a 150 but 2 wheel drive

 

both power steering

 

Is the 250 an Automatic? Is it a Highboy? You list 2 - 76 4x4's. Do you know if the length of the shaft in the column is the same for a highboy and a regular 250 4x4?

 

the 250 is a manual. The higboy steering is sold

 

i am desprate for a 360 fan shroud for my 73 f250, please message me if you have one

 

got any pictures of the 335 series cleveland? Also, what size radiators and condition? pictures of the beds...how much work do they need and what are you asking for them? What part of Mass are you in?

 

How about a exhaust manifold plenum heater valve for my F150 300\6 of 78 vintage? And tan door panels too, maybe... the PO made wooden ones that do the job but, you know. I get a lot of grief bout em! And you wouldn't have the top bracket to hold on to the heat shroud for the intake heat pipe? That'd be awesome if you do! 54896. Oh, and a good chrome bumper without the bracket holes that they put on some models.

 

I currently do not have any of those parts.

 

How about a good dash bezel? Preferably wood grain, non AC and radio slot not cut up. Thanks!

 

Do you have a manual transmission pedal set available? I'm also looking for the complete clutch linkage assembly and manual trans steering column.

 

do you have an air cleaner assembly for a 4bbl laying around and what would you want for it shipped to 44420? If you have a 4100/4150 carb I might be interested as well.

 

I have a 1978 f250 ranger 4wd. would you have rear end links that will work for me?