dynamic and static compression
#1
dynamic and static compression
I'm building a truck motor going through all the paper builds , you know the ones you spend hours on only to find some new thread of information that changes everything.
So here I am rethinking my piston, flat to inverted dome, squish-quench, and cam timing. Oh last but not least compression ratio, dynamic, and static.When will it end thank god I have not ordered my pistons yet.
Dynamic CR
useful site,,http://www.wallaceracing.com/Calculators.htm
So here I am rethinking my piston, flat to inverted dome, squish-quench, and cam timing. Oh last but not least compression ratio, dynamic, and static.When will it end thank god I have not ordered my pistons yet.
Dynamic CR
useful site,,http://www.wallaceracing.com/Calculators.htm
Last edited by akdanstar; 03-18-2014 at 02:59 AM. Reason: text
Thread
Thread Starter
Forum
Replies
Last Post
durk
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
6
04-18-2006 11:10 PM
arkain101
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
3
01-18-2005 10:57 AM
76 F150 Ranger XLT
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
7
03-05-2004 05:01 PM
erikl85
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
11
11-25-2002 10:45 PM