Trying to locate original part numbers
#1
Trying to locate original part numbers
Hi All (again),
Still trying to sort out not so much Dana/Ford part numbers, but how to organise a specific search.
Have given up trying to identify the differing part numbers for the same part (previous post).
Would anyone know how to POSITIVELY locate either a Dana or Ford part number for the upper and lower ball joints on a 1976-1980 Ford F100 4X4 open Knuckle Dana 44 housing? I THINK that the same ball joint was also used in the Jeep CJ's and Inter Scouts same era (1976-1980). Seem to be readily available on fee bay, but often described as 'may fit other vehicles' and again very rarely are original part numbers available. Again, I THINK that regardless of being Dana 30 OR Dana 44, the same upper and lower ball joint was used. Would appreciate any help.
Dave 64
Still trying to sort out not so much Dana/Ford part numbers, but how to organise a specific search.
Have given up trying to identify the differing part numbers for the same part (previous post).
Would anyone know how to POSITIVELY locate either a Dana or Ford part number for the upper and lower ball joints on a 1976-1980 Ford F100 4X4 open Knuckle Dana 44 housing? I THINK that the same ball joint was also used in the Jeep CJ's and Inter Scouts same era (1976-1980). Seem to be readily available on fee bay, but often described as 'may fit other vehicles' and again very rarely are original part numbers available. Again, I THINK that regardless of being Dana 30 OR Dana 44, the same upper and lower ball joint was used. Would appreciate any help.
Dave 64
Thread
Thread Starter
Forum
Replies
Last Post
7702fordboy
Clutch, Transmission, Differential, Axle & Transfer Case
8
12-13-2005 09:13 PM
69crewcab
Clutch, Transmission, Differential, Axle & Transfer Case
4
06-19-2003 11:42 PM