O2 sensor wrench size?
#3
#4
O2 sensor wrench size?
Racerguy, I picked up the O2 socket at Can Tire.thanks again. Now for my next problem, I can get the socket on the O2 sensor but I don't think I can get a rachet on it. This one is on the passenger side of the truck, would it be better to just drop the exaust system down from the manifolds? It might give me a little more room to work with. Thanks for your time and patience. jse
#5
#7
O2 sensor wrench size?
I have tried the 7/8 wrench, I can't get a good enough bite with the open end. I've even bent the wrench to get a better fit. The one on the driver's side is pretty easy to get at, it's the one on the passenger side that is a bi-ch.
Racerguy, I haven't tried a flex ratchet yet. I did take off the front wheel and it does improve the access. I was hoping that you or someone reading this had actually removed this O2 sensor and could tell me how they did it. I may be missing something but right now I can't see how this job can be done with the exhaust system still in place.
Racerguy, I haven't tried a flex ratchet yet. I did take off the front wheel and it does improve the access. I was hoping that you or someone reading this had actually removed this O2 sensor and could tell me how they did it. I may be missing something but right now I can't see how this job can be done with the exhaust system still in place.
Trending Topics
#8
#9
#10
#11
O2 sensor wrench size?
Racerguy! Just got finished puting the new O2 sensor in. You were right with the flex ratchet and O2 sensor socket the job is not too bad. Removing the trans dipstick tube helped as well. Thanks again truck seems good so far (on the driveway) hope it stays that way! JohnE
Thread
Thread Starter
Forum
Replies
Last Post