So I had a wind shield go in my 67 it was fordmoco. Long story short I need to find an NOS or windshield that fits gasket the original is a little longer than ppg replacement.when ppg is installed the ends are literally about an 1/8" or less into the gasket this windshield has been to two shops and it was installed and sealed in what i would call the correct fashion at the second shop only to still leak Got the gasket from Mac's antique.but a nice new gasket is wasted on a bad fit of glass So is anyone else having this issue ? or solutions? thank yous!
eco67jiminny

 

Be sure to use a non-hardening, non-curing, sealant like 3M Glazing and Bedding Compound. The sealer goes on both sides of the gasket. It touches both the glass and the paint. This is not the way they install modern windshields, so you have to ask.

 

C1UB-8903110-A .. Windshield Weatherstrip / Reproduced by Dennis Carpenter.

Applications: 1961/67 Econoline / Standard Cabs without stainless steel windshield reveal mouldings: 1961/66 F100/1100, 1963/69 N/NT/T500/1000, 1967/69 F800/1000.

 

I just read on another forum where someone bought a new windshield that was not wide enough, and they returned it for a replacement.