Transmission identification - help needed
#1
Transmission identification - help needed
After some more work on my 59 F100 that became a 4x4 sometime during its life we need some help doing an ID of the transmission. From the factory it came with the 3 speed with overdrive but in the swap to a 4WD I am not sure what else was changed.
HEF AT 031203
CTR-7a040-0
We just pulled the engine apart and other than one rod it is in great condition. A couple minor details to figure out then I can decide what to do with the truck.
HEF AT 031203
CTR-7a040-0
We just pulled the engine apart and other than one rod it is in great condition. A couple minor details to figure out then I can decide what to do with the truck.
#2
#4
When the 4WD parts were swapped in, they probably removed the 3 speed with overdrive and used the 3 speed (short version) that was usually used with the 4WD setup. This assumes that you have the column shift. I have only seen two transmissions used on the early F100 4WD trucks - the short 3 speed with a column shift and the 4 speed Warner.
Thread
Thread Starter
Forum
Replies
Last Post
stanzianiman
1948 - 1956 F1, F100 & Larger F-Series Trucks
10
09-25-2023 03:40 PM
jdunaway
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
4
01-24-2018 09:20 PM
1_ton_bronco
1961 - 1966 F-100 & Larger F-Series Trucks
4
06-06-2013 06:14 PM
klatt_89
Clutch, Transmission, Differential, Axle & Transfer Case
2
12-25-2005 05:53 AM
redneckdieselmechanic
Clutch, Transmission, Differential, Axle & Transfer Case
1
02-12-2002 11:30 PM