Abs control module replacement
#1
Abs control module replacement
I am getting ready to replace my faulty abs control module. The service manual says to remove the HCU to replace the module. I want to know if there are any tricks to remove the module without having to disconnect the HCU so that I don't have to get the HCU bled.
Tonight I was look in the engine compartment and I was thinking that I could remove the driver side headlight and then cutting an access hole through the steel panel behind the headlight.
Any ideas??
Tonight I was look in the engine compartment and I was thinking that I could remove the driver side headlight and then cutting an access hole through the steel panel behind the headlight.
Any ideas??
Thread
Thread Starter
Forum
Replies
Last Post
7.5GasHog
1968-Present E-Series Van/Cutaway/Chassis
32
03-05-2018 03:45 PM